Truss · Motors · Safety
Truss and Rigging for Events in Los Angeles
Lighten Up designs and installs truss and motor rigging for concerts, corporate events, activations and productions in Los Angeles. Our riggers hang and secure truss, motors and fixtures, read and draw rigging plots, and coordinate with the venue’s house riggers so that every point is rated, checked and documented.
Rigging is planned alongside the lighting and power design, so the loads on each point are known before anything goes in the air.
Our rigging service covers:
- Truss and motor rigging
- Rigging engineering
- Load calculation
- Points and bridles
- Certified riggers
- Vectorworks / CAD
What is event rigging?
Event rigging is the temporary system that holds lighting, audio, video and scenery above or around an event. It usually means truss, the aluminum structure fixtures hang from, lifted by chain motors that are attached to the building’s structure with slings and shackles, or bridles where a single point has to be built from two attachment points.
Every element has a rated working load. Rigging engineering and load calculation make sure the weight of the truss, fixtures and cable on each point stays inside what the motor, the hardware and the building can safely carry.
Flown truss or ground supported truss
Flown truss hangs from rigging points in the venue’s ceiling or roof structure. It keeps the floor clear and puts lighting where it is most useful, but it depends on the building having points rated for the load and on the venue approving the plot.
Ground supported truss stands on its own towers and bases. It is the answer for tents, outdoor sites, older buildings and rooms without usable points, and it needs a footprint on the floor and ballast or bracing planned in from the start.
Which one a show uses comes down to the venue, the load and the look, and many productions use both.
Safety and documentation
Rigging is where planning matters most. Our riggers work from a rigging plot drawn in Vectorworks, coordinate with house riggers on point locations and approvals, and check and document every point before the system is loaded.
What a venue usually asks for
- A rigging plot showing point locations and the load on each point.
- The weight of truss, motors, fixtures and cable being hung.
- Who is rigging and how the work will be supervised.
- Load in and load out times, including when the floor and the air are available.
Requirements vary by venue. Ask your venue for its production or rigging guidelines early and send them with your inquiry.
Questions
Rigging questions
What is the difference between flown and ground supported truss?
Flown truss hangs from the venue’s structure on chain motors. Ground supported truss stands on its own towers, which suits tents, outdoor sites and rooms without rated rigging points.
Do you work with venue house riggers?
Yes. Our riggers coordinate with house riggers on point locations, approvals and the load on each point.
Do you provide rigging plots and load calculations?
Yes. Rigging plots are drawn in Vectorworks and loads are calculated for each point as part of rigging engineering.
Can you rig lighting, audio and video on the same system?
Rigging plans account for everything hanging on the truss. Send the weights and positions from the other departments so they are included in the load calculation.
Tell us about the show.
Send the date, the venue and what you know so far. Floor plans, renders and riders help us scope it faster.